Before First Use - IKEA SKINANDE Manual

ENGLISH
This option deactivates the flow of rinse aid
and salt. The related indicators stay off.
The programme duration can increase.
How to activate the Multitab option
1.
Press at the same time
The multitab indicator comes on.
The function stays on until you deactivate it.
Press and
multitab indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Set the water softener to the highest lev-
el.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.
Acoustic signals
The acoustic signals operate when the ap-
pliance has a malfunction. It is not possible
to deactivate this acoustic signal.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
and
at the same time. The
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
There is also an acoustic signal that oper-
ates when the programme is completed. By
default, this acoustic signal is on, but it is
possible to deactivate it.
How to deactivate the acoustic signal for
.
the end of programme
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Setting
and starting a programme".
2. Press and hold, at the same time,
and
and
flash.
3.
Press .
•
The
off.
•
The indicator continues to flash.
• The display shows the current setting.
Acoustic signal on.
Acoustic signal off.
4.
Press to change the setting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
Clarke
degrees
58 - 63
until the
indicators start to
and indicators go
Water softener
adjustment
Level
10
8
,