Getting Started - Remington PG6032 Manual

ENGLISH

GETTING STARTED

CHARGING YOUR APPLIANCE
• Before using your groomer for the first time, charge for 14-16 hours.
• Ensure the product is switched off.
• Place your groomer into the stand, connect the adaptor to the product and then to the
mains.
• The charging indicator will illuminate.
• The charging indicator will remain illuminated once fully charged.
• Your appliance cannot be overcharged. However, if the product is not going to be used
for an extended period of time (2-3 months), unplug it from the mains and store.
• Fully recharge your appliance for 16 hours when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then recharge for
14-16 hours.
INSTRUCTIONS FOR USE
ATTACHING AND REMOVING GUIDE COMBS
To attach:
With the trimmer blade facing away from you, slide the guide comb on top of the trimmer
blade and click into position.
To remove:
With the trimmer blade facing away from you, carefully push the guide comb away from the
trimmer blade.
BEFORE YOU BEGIN
• Comb facial hair with a fine comb before you start trimming.
• Hairs should be dry and without any waxes or lotions before using the groomer.
TO THIN AND TAPER THE BEARD/MOUSTACHE
• Attach the wide trimmer blade.
• Place the hair length attachment on the trimmer blade, select the desired length and
switch on.
• Start trimming under the chin, following the jawbone line. Work toward the ear and
upper beard line using an upward motion.
TO TRIM EDGE OF BEARD OR MOUSTACHE
• Attach the wide trimmer blade.
• Hold the groomer with the cutting blade facing you.
• Start with edge of beard/moustache line, and with the cutting blades resting lightly
against your skin, use slow movements to create a beard/moustache line.
4