Table of Contents
Advertisement
30
SIDE BURNER TROUBLESHOOTING
PROBLEM
Side Burner does not light.
Flame is low in HIGH position
Push button ignition does not
work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area
using the contact information on our web site. Log onto www.weber.com
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should
be in the OFF position.
Make sure black wire is connected between the igniter and electrode
(1). Make sure white wire is connected between the igniter and grounding
clip
(2). Spark should be a white/blue color, not yellow.
1)
Igniter Wire
2)
Ground wire
3)
Burner
CHECK
Is gas supply off?
The excess fl ow safety device,
which is part of the barbecue to
cylinder connection, may have
activated.
Is the fuel hose bent or kinked?
Does burner light with a match?
(1)
Turn supply on.
To reset the excess fl ow safety device turn all burner control
knobs and the cylinder valve OFF. Disconnect the regulator
from the cylinder. Turn burner control knobs to HIGH. Wait at
least 1 minute. Turn burner control knobs OFF. Reconnect the
regulator to the cylinder. Turn cylinder valve on slowly. Refer to
"Lighting Instructions".
Straighten hose.
If match lights burner, check igniter (see below).
®
.
Side Burner Grate
Side Burner Cap
Side Burner Ring & Head
Igniter Electrode
Control Knob
(2)
CURE
(3)
(1)
(2)
Advertisement
Table of Contents
Troubleshooting
