Rotisserie Troubleshooting - Weber SUMMIT 38008 Owner's Manual

ROTISSERIE TROUBLESHOOTING

PROBLEM
Burner does not light.
Burners do not light. -or- Burner hsa
asmall fl ickering fl ame
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your
area using the contact information on our web site. Log onto www.weber.com
CHECK
Did you hold the burner control knob
down and hold down for 20 seconds until
after burner ignited?
Did you wait to see the entire ceramic
surface become alight before counting 20
seconds?
Is the igniter sparking?
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
CURE
Try to relight burner by holding burner
control knob down and continue holding
down until 20 seconds after burner has
ignited.
When relighting burner by holding burner
control knob down, wait to see the entire
ceramic surface become alight before
counting 20 seconds?
Replace battery in igniter button module.
Reseat burner ring.
To reset the excess fl ow safety device
turn all burner control knobs and the
cylinder valve OFF. Disconnect the
regulator from the cylinder. Turn burner
control knobs to HIGH. Wait at least 1
minute. Turn burner control knobs OFF.
Reconnect the regulator to the cylinder.
Turn cylinder valve on slowly. Refer to
"Lighting Instructions".
®
.
31