Weber SUMMIT 38008 Owner's Manual page 29

MAIN AND SMOKER TROUBLESHOOTING
PROBLEM
Burners burn with a yellow or orange
fl ame, in conjunction with the smell of
gas.
Burners do not light. -or- Burners have
a small fl ickering fl ame in the HIGH
position. -or-
Barbecue temperature only reaches
250˚ to 300˚ in the HIGH position.
Burner does not light, or fl ame is low
in HIGH position.
Experiencing fl are-ups:
CAUTION: Do not line the bottom
tray with aluminum foil.
Burner fl ame pattern is erratic. Flame
is low when burner is on HIGH. Flames
do not run the whole length of the
burner tube.
Inside of lid appears to be "peeling."
(Resembles paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area
using the contact information on our web site. Log onto www.weber.com
CHECK
Inspect Spider / Insect Screens for
possible obstructions. (Blockage of
holes.)
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the Left burner light with a match?
Are you preheating barbecue in the
prescribed manner?
Are the cooking grates and Flavorizer
bars heavily coated with burned-on
grease?
Is the bottom tray "dirty" and not allowing
grease to fl ow into catch pan?
Are burners clean?
The lid is stainless steel, not paint. It
cannot "peel". What you are seeing
is baked on grease that has turned to
carbon and is fl aking off.
THIS IS NOT A DEFECT.
Clean Spider / Insect Screens. (See Section
"Annual Maintenance")
To reset the excess fl ow safety device turn
all burner control knobs and the cylinder
valve OFF. Disconnect the regulator from the
cylinder. Turn burner control knobs to HIGH.
Wait at least 1 minute. Turn burner control
knobs OFF. Reconnect the regulator to the
cylinder. Turn cylinder valve on slowly. Refer
to "Lighting Instructions".
Refi ll LP cylinder.
Straighten fuel hose.
If you can light the Left burner with a match,
then check the Crossover
All burners on high for 10 to 15 minutes for
preheating.
®
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
®
.
29
CURE
®
ignition system.