Janome Memory Craft 9850 Instruction Book page 42

v
t
b
n
m
q
v Lower the buttonhole foot and pull down the
Start sewing while pulling the needle thread lightly to
t Buttonhole lever
y
NOTE:
A warning message will appear and the machine will
stop automatically if you start the machine without pulling
Make sure there is no gap between the slider and front
stopper, otherwise the buttonhole will be out of position or
y No gap
b The buttonhole is sewn automatically in the
the machine will stop automatically with the needle in
n
m
Patterns B3 to B6 are sensor buttonholes and the sewing
However, the sewing sequence varies depending on the
NOTE:
Use the stabilizer plate (optional item) when sewing thick
NOTE:
When sewing a buttonhole on thick fabric which has a
Use a pin q
Make sure the fabric does not move the lever when
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
38