Dab Operation; Full Scan; Manual Tuning; Secondary Services - Hitachi AXM1204E Instruction Manual

DAB Operation

If the unit is connected to the mains power and then switched on from standby for the first
time, the unit will automatically enter into the DAB mode and perform auto scan function.
During the scan the display will show "Searching..." together with a slide bar that indicates
the progress of the scan and the amount of stations that have been found so far.
Once the scan has finished, the unit will select the first alphanumerically found station. To
explore the found stations, press (tap)

Full Scan

The full scan will search for the entire DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
1. To activate auto scan, press (tap)
progressing slide bar.
2. All the stations that have been found will be stored automatically. To explore and listen
to the found stations, press (tap)

Manual Tuning

As well as the auto tune function, you can manually tune the receiver. This can help you
when aligning your aerial or when adding stations that were missed while auto tuning.
1. Press and hold (tap and hold)
to select <Manual tune>, and then press SELECT/MOnO/ST. to
2. Press (tap)
select.
3. Press (tap) to cycle through the DAB channels, which are numbered from 5A to
13F.
4. After your desired channel number is selected, press SELECT/MOnO/ST. to confirm.
The display will show the multiplex.
5. Press (tap) to see what stations are present in the found multiplex.
6. Once you have reached the last station in the found multiplex, the unit will revert back
to the first station again.

Secondary Services

You may see a ">" symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press SELECT/MOnO/ST. when the ">" appears in
the display before the station name. When the secondary service ends, the unit will
automatically switch back to the primary station.
.
and the display will show "Scanning ..." and a
to select.
/ MEnU to display the menu.
GB
21