Dab Operation; Full Scan; Manual Tuning; Secondary Services - Hitachi AXM920E Instruction Manual

DAB Operation

Before switching your unit on, please fully extend the aerial.
If the unit is connected to the mains power and then switched on from standby mode for
the first time, the unit will automatically enter into the DAB mode and perform a full auto
scan function. During the scan the display will show "Searching..." together with a slide bar
that indicates the progress of the scan and the amount of stations that have been found so
far.
Once the scan has finished, the unit will select the first alphanumerically found station. To
switch the found stations, press the SKIP/TUNE SEARCH
remote control.

Full Scan

The full scan will search for the entire DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
1. To activate auto scan, first tap the
button on the remote control to select "Full Scan", the display will show "Searching ..."
and a progressing slide bar.
2. All the stations that have been found will be stored automatically. To explore and
select listening to the found stations, press the SKIP/TUNE SEARCH
or the remote control to select.

Manual Tuning

You can manually tune the receiver. This can help you when aligning your aerial or when
adding stations that were missed while auto tuning.
Press and hold the SELECT/MONO/ST. button on the remote control to enter the
1.
manual tuning mode. The display will show "Manual Tune", and then display the
current station frequency.
Press the SKIP/TUNE SEARCH
2.
cycle through the DAB channels, which are numbered from 5A to 13F.
3. After your desired channel number is selected, press the SELECT/MONO/ST. button
on the remote control to confirm. The display will show the multiplex.
If you wish to exit Manual Tuning mode, press the SELECT/MONO/ST. button on the
4.
remote control.

Secondary Services

You may see a ">" symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press the SELECT/MONO/ST. button on the remote control.
When the secondary service ends, the unit will automatically switch back to the primary
station.
buttons on the unit or the
/SCAN icon on the unit or press the
buttons on the unit or the remote control to
GB
/SCAN
on the unit
19