Nl Originele Handleiding - Hilti TE 60-A36 Original Operating Instructions

Trouble or fault
The insert tool cannot be re-
leased from the chuck.
Product does not start.
The service indicator lights.
The service indicator blinks.
The ON/OFF indicator
flashes.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Originele handleiding
1 Informatie over documentatie
1.1 Over deze documentatie
• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
• De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
1.2 Verklaring van de tekens
1.2.1 Waarschuwingsaanwijzingen
Waarschuwingsaanwijzingen waarschuwen voor gevaren bij de omgang met het product. De volgende
signaalwoorden worden gebruikt:
GEVAAR
GEVAAR !
▶ Voor een direct dreigend gevaar dat tot ernstig letsel of tot de dood leidt.
*2201898*
Possible cause
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
The electronic restart interlock is
activated after an interruption in
the electric supply.
Service limit time reached.
The product is faulty.
Product momentarily overloaded.
Protection against overheating.
2201898
Action to be taken
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
▶ Switch the product off and then
on again.
▶ Have the product repaired by
Hilti Service.
▶ Have the product repaired by
Hilti Service.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down
and clean the air vents.
Nederlands 25