Hilti TE 60-A36 Original Operating Instructions page 26

Drill bits for metal, Ø
Drill bits for wood, Ø
Chuck
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values in accordance with EN 60745
Sound pressure level (LpA)
Uncertainty for the sound pressure level (KpA)
Sound power level (LWA)
Uncertainty for the sound power level (KWA)
Total vibration in accordance with EN 60745
Hammer drilling in concrete (a
Uncertainty (K)
Chiseling in concrete (a
Uncertainty (K)
5 Operation
5.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments or changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.1.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the product.
20 English
)
h, HD
)
h, CHeq
2
3
TE 60-A36
10 mm ... 20 mm
10 mm ... 32 mm
TE­Y
TE 60-A36
98 dB
3 dB
109 dB
3 dB
TE 60-A36
8.3 m/s²
1.5 m/s²
6.7 m/s²
1.5 m/s²
2201898
*2201898*