Hilti TE 60-A36 Original Operating Instructions page 25

3.6 Quick-release chuck (accessory)
The quick-release chuck makes changing accessory tools a quick operation with no additional tools needed.
It is suitable for accessory tools with cylindrical or hexagonal shank used in the "With hammering action
mode.
3.7 Service indicator
The product is equipped with a service indicator LED.
3.7.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.7.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED flashes, the product is not in working order.
4 LEDs flash, the product is not in working order.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.8 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4 Technical data
Rated voltage
Weight in accordance with EPTA procedure 01
Single impact energy in accordance with EPTA procedure 05
Hammer drill bits, Ø
Breach bits, Ø
Percussion core bits, Ø
PCM diamond core bits, Ø
*2201898*
Meaning
Servicing is due.
Have the product repaired by Hilti Service.
The product is switched on
The product is switched off because of a transient
fault.
The product is switched off.
The product is working at half power.
The product is working at full power.
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
2201898
"
TE 60-A36
36 V
8.1 kg
8.1 J
12 mm ... 40 mm
40 mm ... 80 mm
45 mm ... 100 mm
42 mm ... 102 mm
English 19