Installation
Tools and aids
You will need some manual skill for the installation. Please observe the sequence of the specified
installation steps.
Have the following equipment ready before beginning:
– Phillips screwdriver
– Drilling machine with drill bit
– Wall plugs and screws
– Measuring tape/folding ruler
– Level
– Pencil
– Stable step ladder
– Activated carbon filters for air recirculation mode
– Mounting template
Important!
Some steps are much easier to complete if another person
helps with handing
Removing the protective film
The painted surfaces of your new cooker hood are covered with a film to protect them
from scratching during transport. Do not remove the protective film until the final mounting
of the cooker hood.
Danger of injury!
Please note that some internal areas of the device may have sharp edges.
Installing the cooker hood
Caution!
Make sure that no cables or pipes are damaged when drilling the holes.
Important!
Follow the instruction manual of your stove! If the spacing indicated there is
larger than 65 cm, this must be taken into account.
1. Turn off the device and disconnect it from the power supply before installation.
- 31 -