Avaya B199 Manual page 36

Settings configuration and management
Name
Webapp debug
Daisy Chain
Factory Reset
Time
Enable NTP
NTP Server
August 2020
Description
To enable or disable the debugging function for the web application. It activates
the web application logging available in the System Logs tab. By default,
Webapp Debug is off.
Note:
You can use this function only through the web interface.
To choose a mode, in which your B199 Conference Phone operates in case of
a daisy chain arrangement. The options are:
• Master. This is the default setting.
• Slave
Note:
You can configure this parameter if you logged in with the administrator
password.
To reset the phone to its factory settings. By resetting the phone to its factory
settings, you remove all the configurations set, imported and installed in course
of the phone use.
Note:
You can do the factory reset only if you log in with the administrator
password and only on the phone.
To enable or disable the Network Time Protocol (NTP). By default, NTP is
enabled.
Note:
You can configure this parameter if you logged in with the administrator
password.
To specify the NTP server when NTP is enabled. By default the phone uses the
following NTP server: 0.pool.ntp.org.
Note:
You can configure this parameter if you logged in with the administrator
password.
Using Avaya Conference Phone B199
Comments on this document? infodev@avaya.com
Table continues...
36