Table of Contents
Advertisement
Safety Practices and Hazards
Verifying Safe State
The following general safety precautions must be observed during all
phases of operation, maintenance and service of this instrument.
To ensure continued safety of the instrument after maintenance or
service procedures, verify the instrument is returned to a safe state
for the user. This includes running performance checks to verify the
instruments safety systems are functioning correctly. Check the
general condition of the instrument during operation for wear or
signs of corrosion that are likely to inhibit function or safety.
Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the instrument. Agilent
Technologies assumes no liability for the customer's failure to
comply with these requirements.
Hazard Warnings
In addition to the hazard warnings specified in your spectrometer
operation manual, specific hazard warnings have been included in
this operation manual. These warnings state the hazard, describe
how to avoid it and specify the possible consequences of not
following the instructions. Read all warnings carefully and observe
them at all times.
Electrical Hazards
The SIPS electronic control module contains electrical circuits,
devices and components operating at dangerous voltages. Contact
with these circuits, devices and components can cause death, serious
injury or painful electric shock. Panels or covers retained by screws
on the SIPS may be opened only by an Agilent field service engineer.
A blown fuse should be replaced only with one of the size and rating
specified in the text adjacent to the fuse holder. Always ensure that
the accessory is turned off and disconnected from the mains supply
before attempting any replacement.
10
Agilent Sample Introduction Pump System SIPS 10/20 User's Guide
Advertisement
Table of Contents
