Remote Access; Remote Access Commands; Commands During Playback Mode - VTech I6787 User Manual

Answering system operation

Remote access

You can access many features of your answering system remotely from any touch tone telephone.
A two-digit security code is required to access the system and the factory default code is 19; see
page 29 to change it. To connect remotely:
• Dial your telephone number from any touch tone telephone.
• When the system answers and announces the greeting, enter the two-digit security code.
• After hearing a double beep, enter one of the remote commands in the following table.
• Hang up or press 8 to end the call.

Remote access commands:

Hang up Saves all messages
1 Plays all messages
2 Plays new messages only
3 (twice) Deletes all old messages while no message is currently playing.
*5 Plays help menu
5 To stop
*7 Records the outgoing announcement
8 Hang up the call
0 Turns answering system on or off

Commands during playback mode:

3 Deletes the message currently playing and announces "Message deleted."
4 Repeats the playing message
4 (twice) Plays the previous message
6 Skips to the next message
www.vtechphones.com
• Your memo can
be up to four
minutes in length.
• If no key is
pressed after
entering remote
access, any
new messages
will be played
automatically.
• Once the new
messages have
been played,
the system
will announce
the help menu
options. If no key
is pressed within
20 seconds,
the remote
access call is
automatically
disconnected.
33