Table of Contents
Advertisement
®
LazerData
12000 Scanner
2.2
GUIDE TO INSTALLATION
Use the following checklist to ensure a complete installation of your LazerData
12000 Scanner.
1) Read all information in the section "Safety Precautions" at the beginning of this
manual.
2) Open the scanner to select the main serial interface type as required (see
sections 2.3 and 2.4).
3) Correctly position and mount the scanner for bar code reading according to the
information in sections 2.5, 2.8, and 3.4.
4) Provide correct system cabling according to the signals necessary (see the
applicable subsections under sections 2.6 or 2.7).
5) Configure the software parameters from a host computer using either the
LDHOST interface utility program provided on diskette, or using the Host Mode
programming procedure by ESC sequences via the serial interface.
For more details about these configuration methods refer to the section
"LazerData 12000 Scanner Configuration" in the LDHOST Help Online.
Use the Test Mode, as described in LDHOST, to fine-tune the
scanner position for optimum bar code reading. For further
details, refer to the section "Test Mode" in the LDHOST Help
Online.
The installation is now complete.
2.2 - Installation
NOTE
Installation Manual
Advertisement
Table of Contents
