Installation Manual
2.3
OPENING THE DEVICE
Before installing the LazerData 12000 Scanner it may be necessary to open the
scanner to select the interface required.
The scanner must be disconnected from the power
supply during this operation.
Refer to the following instructions and diagram below when opening the reader:
•
Unscrew the four screws as shown below to open the scanner for access to the
output interface jumper.
•
Carefully remove the cover of the scanner. Avoid any contact with the
mirrored rotor, the lenses, or other optical components.
Figure 2.2 - Opening the LazerData 12000 Scanner
WARNING
®
LazerData
12000 Scanner
Installation - 2.3