Optional Lithium-Ion Battery; Table 2 Charger/Adaptor And Battery Indicators - Olympus Magna-Mike 8600 User Manual

Hall-effect thickness gauge
Table of Contents

Advertisement

The power status of the charger/adaptor and the battery charge condition are both
indicated on the front panel of the Magna-Mike 8600, as well as in the user interface
(see Table 2 on page 27).
Charger/adaptor
indicator light
Red
Off
Green
1.4.2

Optional Lithium-Ion Battery

The Magna-Mike 8600 is normally used as a bench-top instrument and continuously
powered from the charger/adaptor supplied with the instrument. The lithium-ion (Li-
ion) battery is an optional method for powering the Magna-Mike 8600. When
properly maintained, and when the instrument is operated under typical inspection
conditions, the lithium-ion battery should provide between 15 and 16 hours of
continuous operation.
To install or replace the lithium-ion battery
1.
Unfold the instrument stand.
2.
At the back of the instrument, loosen the two thumb screws securing the battery
compartment cover (see Figure 1-10 on page 28).
3.
Remove the battery compartment cover (see Figure 1-10 on page 28).
4.
Remove the battery and/or install the battery in the battery compartment.
5.
Ensure that the gasket of the battery compartment cover is clean and in good
condition.

Table 2 Charger/adaptor and battery indicators

AC line power
connected
Yes
Internal battery is charging.
No
Charger/adaptor is not connected.
Internal battery is fully charged.
OR
Yes
Charger/adaptor is connected, but
no battery is installed.
DMTA-10026-01EN, Rev. D, January 2015
Indicator meaning
Instrument Overview
Battery
indicator
(located at
bottom right
of display)
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents