Table of Contents
Advertisement
0 Installationof the ER-52CB S10 interface cable and ER-OIFD
3.5-inch floppy disk unit (for data transfer between the ER-31OO
and the ER-OIFD)
1.
Refer to the ER-OIFD InstallationManual.
2.
Connect the ER-52CB to the S10 connector on the left side of
the ER-31OO and to the serial interface connector (@)
of
the ER-OIFD (see Fig. 13).
3.
Open the cover on the right side
its programming. (Refer to 8.6
of the ER-OIFD and perform
"Use of the ER-OIFD".)
Frontview
Backview
POWERLED
ON whentheERO1.FD poweris on.
ERRORLED
ON whenthe FD read/write e rror
is met. Also,usedto indicate
diskinitialization.
ERRORLED
On at a datatransfer e rror.
Also,usedto indicate d isk
initialization.
RUN key
Usedto startdatatransfer
between theEROIFD and the ECR.
3.5"FD
Serial interface c onnector
(~L level)
Serial interface c onnector
(RS232C level)
POWERswitch
AC adapter jack
AC adapter
b
Fig. 13
8.3 Operational check
Perform the S10 test in the SRV mode.
Testing of the ER-52cB requires the ER-52cB, loop back connector
(UKOG-6651RCZZ) , and service key; and testing of the ER-67Lc
requires the ER-67LC, ER-52cB, loop back connector
(UKOG-6639RCZZ) , and service key.
–44–
- Quick Links:
- Programming
Hide quick links:
Advertisement
Table of Contents
