Table of Contents
Advertisement
Step Nine - Install Cable Organizer
1
Use the Cable Organizer's bracket as a
guide to mark the location on the wall for
the two mounting screws.
NOTE: The height of the bracket should
ensure that the charging connector is
located at a maximum of 48" from floor
level.* The minimum height is 18" (46 cm) if
mounting indoors, and 24" (61 cm) if
mounting outdoors.
*CAUTION: If installing in a public
location, consider laws and
regulations that accommodate persons
with disabilities (for example, the
American with Disabilities Act).
2
Drill two 3/16" (4.8 mm) holes in the wall.
3
Insert the two Poly-Set anchors into the
holes until their flanges are flush.
4
Use the supplied Phillips screws and
washers to secure the bracket to the wall.
To ensure the screws are secure, apply
additional turns after the screw head is
against the bracket:
Drywall
Thickness
3/8"
1/2"
5/8"
3/4"
NOTE: For more details on using the
anchors and screws, refer to the Poly-Set
Installation Instructions, included in the
shipping box.
Number of
Additional Turns
7-9
5-7
3-4
1-2
5
Slide the Cable Organizer onto the bracket
as shown. If desired, you can insert the
High Power Wall Connector's cable into
the groove between the bracket and the
Cable Organizer, as shown.
17
Advertisement
Table of Contents
