Table of Contents
Advertisement
Installation Overview
TOOLS REQUIRED
Before installing the High Power Wall
Connector, ensure you have the following
tools:
•
Pencil or marker
•
Drill and 9/32"and 3/16" drill bits
•
T20 torx driver
•
Hole saw (1 1/4" / 32 mm)
•
Sharp knife or razor
•
Phillips screwdriver
•
Ratchet wrench with 8 mm and 17 mm
sockets, and a 2" (minimum) extension
•
Voltmeter or digital multimeter (to
measure AC power at the site)
OVERVIEW OF STEPS
After running service wiring to the desired
installation location using 1" (25 mm) conduit,
(see pages 4 through 6), and installing the
appropriate circuit breaker (see page 7), TURN
OFF THE POWER SUPPLY. Then follow these
steps to install the High Power Wall
Connector:
1
Check box contents (see page 9)
2
Install wall bracket (see page 10)
3
Prepare for installation (see page 11)
4
Mount on wall (see page 12)
5
Connect wiring (see page 13)
6
Confirm a successful installation (see
page 14)
7
Set operating current (see page 15)
8
Secure cover and power up (see page 16)
9
Install Cable Organizer (see page 17)
8
HIGH POWER WALL CONNECTOR INSTALLATION GUIDE
Advertisement
Table of Contents
