Panasonic KX-FT33NZ Operating Instructions Manual page 43

Receiving Faxes
Receiving faxes using an extension telephone =
When you connect an extension telephone on the same line, you can receive fax documents usina the
extension telephone. You do not have to go to the unit and press START/COPY/SET
Important:
• Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1
2
When the extension telephone rings, lift the
handset of the extension telephone.
When:
— document reception is required,
a fax calling tone (slow beep) is heard, or
— no sound is heard,
press [9j (pre-selected fax activation code)
firmly
3 Hang up the handset.
• The unit will start reception.
Note:
• You can change the fax activation code (see
below).
Changing the fax activation code =====
The fax activation code is used when receiving faxes using an extension telephone (see above).
1
2
3
4
5
6
7
8
Press IMENU).
Display:
f 1.SYSTEM SET UP
Press [a], then T T\
FAX ACTIVATION
Press START/COPY/SET 1.
i
MODE=ON VA
Press
▼
or I A to select the desired setting.
• If this feature is not required, select "OFF".
Press START/COPY/SET .
CODE= * 9
• The display will show the pre-selected code.
Enter the new code number.
• This code can be from 2 to 4 digits in length
using 0 - 9 and * .
Press START/COPY/SET .
i— --------——
SETUP ITEM [
Press MENU .
Dial keypad ( ME NU
:i t) [
2
) (V>:
: © ©
1
i® ® ®iv°c=
(V) wT) fcY ©r-
C=i
□
o]
c=> o a O ( li
3
J
□bm
START/COPY/SET
Note:
• If you subscribe to some special telephone
company services, all or part of the fax
activation code must be different from the
service access code.
• The fax activation code should not be set to
"
0000
".
46