Vision Fitness E3600HRT Assembly Manual page 6

BLUE BAG
2
STEP
• Slide the console mast boot onto the
console mast.
• Unfold the wire harness located in
the console mast frame bracket.
Connect it to the wire tie coming from
the bottom of the console mast. Pull
the wire tie and wire harness up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the mast to the frame using
six lock washers (M8) and six screws
(M8x15L). Tighten with the 5mm Allen
Wire Harness wrench. Place the seventh screw
(M8x15L) in the rear of the frame
bracket and tighten until snug.
• Slide the console mast boot down
and snap it into place on the side cover.
• Remove the nuts (M8) from the
bottom of the seat. Attach the seat to the
seat post with the nuts you just removed.
Heart Rate
Tighten with the 15mm wrench.
Wires
Console Mast
2
STEP
Console Mast
Boot
Frame
Bracket
6