Page 1
A s s e m b l y G u i d e E3600HRT COMMERCIAL UPRIGHT FITNESS BIKE...
Page 2
Also, during each assembly step, ensure that ALL screws are in place and partially threaded in before completely tightening any ONE screw. STEP STEP A s s e m b l y G u i d e E3600HRT COMMERCIAL UPRIGHT FITNESS BIKE STEP STEP...
Page 3
TOOLS & PARTS INCLUDED Screwdriver 15mm Pedal Wrench 5mm Allen Wrench PARTS BOX Console Mast Cover Water Bottle & Cage Color-coded Hardware Bags Owner’s Guide Assembly Guide Warranty Card Heart Rate Chest Strap...
HARDWARE INCLUDED ORANGE BAG PINK BAG M8 x 65L Screw M8 x 20L Screw Quantity: 2 Quantity: 2 M8 Lock Washer M8 x 20L Screw Quantity: 4 M8 Lock Washer Quantity: 2 Quantity: 2 BLUE BAG M8 Lock Washer M8 x 15L Screw Quantity: 6 Quantity: 7...
Page 5
ORANGE BAG STEP • Install the rear foot with four lock washers (M8), two inside screws (M8x65L), and two outside screws (M8x20L). Tighten with the 5mm Allen wrench. STEP Rear Foot...
Page 6
BLUE BAG STEP • Slide the console mast boot onto the console mast. • Unfold the wire harness located in the console mast frame bracket. Connect it to the wire tie coming from the bottom of the console mast. Pull the wire tie and wire harness up through the top of the console mast while simultaneously sliding the mast...
Page 7
PINK BAG STEP • Feed the heart rate wires of the handlebar through the small hole located in the front of the console mast. Pull these wires up through the hole at the top of the console mast. Attach the handlebar to the console mast using two lock washers (M8) and two screws (M8x20L).