Montigo H34VO Series Installation & Maintenance Manual page 19

Section 9: Start-up Sequence with Honeywell Ignition
A. This appliance has a pilot which is lit automatically. Do
B. BEFORE LIGHTING smell all around the appliance area
1. STOP! Read the safety information above on this label.
2. Turn the fireplace "OFF" using the wall switch or remote
3. Wait 5 minutes to clear out any gas. If you smell gas,
4. Turn the fireplace "ON" using the wall switch or remote
1. Turn the fireplace off using the wall switch or remote
2. Turn off all electrical power to the appliance.
XG0150 - 140707.2
Operation
for Your safeTY - read Before liGhTinG:
A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this
appliance and must be installed for the protection
of children and other at-risk individuals.
WarninG if the information in these instructions are not followed
exactly, a fire or explosion may result causing property damage,
personal injury or death.
WarninG / cauTion: hot while in operation. do not touch.
severe burns may result. Keep children, clothing, furniture,
gasoline and other liquids having flammable vapors away.
see installation and operating instructions accompanying this appliance.
not attempt to light the pilot by hand.
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
■ Do not try to light the appliance.
■ Do not touch any electrical switch. Do not use any
phone in your building.
■ Immediately call your gas supplier from a
neighbour's phone. Follow the gas suppliers
instructions.
liGhTinG insTrucTions:
control.
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
control.
NOTE: This unit is equipped with an ignition system
that lights the pilot burner automatically. Do not
attempt to light the pilot by hand.
This unit is equipped with advanced safety
controls including pre and post purge timers.
The fireplace will not turn on until all of the
safety conditions are met. The fans in the
fireplace may operate for an extended period of
time even after the wall switch is turned off.
To Turn off Gas To appliance:
control.
DANGER
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
■ If you cannot reach your gas supplier, call the Fire
Department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it. Call a qualified service
technician. Force or attempt to repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
5. The wall switch LED and heat sensor LED will light up.
6. Once the predetermined airflow is established in the
firebox, the flue gas switch LED will light up after 30
seconds.
7. After approximately 1 minute the hot surface igniter will
start to glow. The pilot will light up, followed by the main
burner. The fireplace will then start up.
NOTE: If the igniter does not glow, even after 3 minutes
have passed, follow the instructions "To Turn Off
Gas To Appliance" and call your service
technician or Montigo dealer.
Control box LED lights
3. Locate the gas shut off valve for the appliance and
turn off.
Divine Outdoor Gas Fireplace
Page 19