Installing the Screen
Step 1). The RTSCH**VO Screen Installation Kit con-
tains two mounting brackets. One for each side of the
Screen Assembly.
Left
Figure 1.
Step 2). The lower portion of the mounting brackets can
be identified by the small cutout and brass nutsert. The
top contains a tab which is used for aligning the bracket.
Figure 2.
Figure 3.
XG0150 - 140707.2
Installation
Tools Required
•
Drill / Driver
•
Phillips Screwdriver
1/4" Hex driver
•
1/8" drill bit (Optional)
•
Right
Bottom
Top
Step 3). Align the cutout on the bottom of the left bracket
with the lower, left corner of the fireplace.
Figure 4.
Figure 5.
Step 4). Align the tab on the top of the left bracket so
that it is flush with the outer edge of the fireplace.
Figure 6.
Divine Outdoor Gas Fireplace
Section:
Page 15