Stihl MS 460 Service Manual page 77

: Remove front handle mounting
screws from underside of
machine.
– Remove the front handle.
On machines heated handles,
disconnect the heating element,
b 14.4
– Disconnect connector between
generator and rear handle
heating element, b 7.5
– On machines with carburetor
heating, disconnect connector of
wire to heating element, b 7.5
– On machines heated handles,
remove the heater switch, b
14.2
: Disconnect short circuit wire (1)
and ground wire (2) from the
contact springs.
76
: Ease the plug (arrow) out of the
annular buffer at the starter side.
: Take the screw (arrow) out of the
buffer.
– Remove the inner side plate,
b 5.4.2
1
2
– Remove the chain catcher,
b 5.2
: Take the plugs (arrows) out of the
annular buffers at the clutch side.
: Take out the annular buffer
mounting screws (arrows).
: Pull the tank housing forward and
push the manifold flange out of
the tank housing at the same
time.
: Pull the impulse hose off the
nipple.
MS 460, MS 460 C