Stihl MS 460 Service Manual page 38

– Pull short circuit and ground
wires out of the housing.
: Pull impulse hose off the nipple
(arrow).
– At the clutch side, take the
screws out of the annular buffers,
b 12.8
– At the flywheel side, take the
screw out of the lower annular
buffer, b 12.8
– Remove the crankcase from the
tank housing.
– Remove the oil seals, b 6.3
MS 460, MS 460 C
: Hold the self-locking nut steady
and take out the screw (arrow).
– Remove the spiked bumper.
: Take out the screws (arrows) that
join the two halves of the
crankcase.
– Pull the heat reflecting foil off the
crankcase.
1
: At the chain tensioner side of the
crankcase, use a 5 mm drift (2) to
drive the dowel pin out of the two
halves of the crankcase.
2
1
– Back off the spindle (1) of service
tool AS 5910 007 2205 all the
way.
: Slip service tool AS (2) over the
two collar studs.
: Fit the hex nuts (3) (for sprocket
cover) and tighten them down by
hand.
: Turn the spindle (1) of the service
tool clockwise until the crankshaft
is pressed out of the ball bearing.
The two halves of the crankcase
separate during this process.
– Remove the service tool AS.
2
: Remove the gasket from the
crankcase.
3
37