Stihl MS 460 Service Manual page 41

This operation must be carried out
very quickly because the bearing
absorbs heat immediately and
begins to expand.
1
: If it is not possible to heat the
flywheel side of the crankcase,
use press arbor (1)
1118 893 7200 to press home the
ball bearing as far as stop.
– Wait for crankcase to cool down.
: Push the annular buffer home so
that its annular groove (1)
engages the housing rib (2).
40
2
: Fit the tank cap's cord (1) in the
groove (2) and pull it forward.
: Place the oil pump in position.
– Insert screws and tighten them
down firmly, b 3.5
– Heat the area of the ball bearing
on the clutch side of the
crankcase to about 150 °C
(302 °F).
2
1
1
1
: Place the ball bearing, with
shoulder (1), on the inside of the
crankcase and push it home by
hand against the oil pump.
This operation must be carried out
very quickly because the bearing
absorbs heat immediately and
begins to expand.
1
: If it is not possible to heat the
clutch side of the crankcase, use
press arbor (1) 1118 893 7200 to
press home the ball bearing as
far as stop.
MS 460, MS 460 C