– Wait for crankcase to cool down.
: Push the stop buffer into the
guide so that its lugs are behind
the housing rib.
2
1
: Push the two annular buffers,
tapered end first, into position so
that their annular grooves (1)
engage the housing rib (2).
: Install the suction hose, b 11.1
1
: Screw spindle of service tool ZS
(2) 5910 007 2200 fully home
and then screw the threaded
sleeve (1) 5910 893 2420 onto
the spindle.
MS 460, MS 460 C
– Lubricate tapered stub of
crankshaft with oil.
: Place tapered stub of crankshaft
in ball bearing at the flywheel side
of the crankcase.
2
1
2
: Screw threaded sleeve (1) to
thread (2) of crankshaft stub.
: Hold the spindle steady and
rotate the service tool counter-
clockwise until the drilled plate
butts against the crankcase.
: Turn the spindle clockwise until
the crankshaft locates against the
ball bearing.
The connecting rod must point
toward the cylinder flange while the
crankshaft is being installed.
41