Stihl MS 460 Service Manual page 36

: Carefully slide the cylinder over
the piston, the clamping strap
moves downwards at the same
time.
– Remove the clamping strap and
wooden assembly block.
: To pull the manifold flange
through the intake opening in the
tank housing, wind a piece of
string (1) (about 15 cm long)
around the back of the flange and
pass the ends of the string
through the intake opening.
: Press the manifold down.
MS 460, MS 460 C
: Pull the ends of the string
outward.
The manifold flange is pulled
through the tank housing intake
opening without damaging the
manifold.
– Check that flange is properly
seated in the tank housing.
1
: Fit sleeve (1) in manifold.
: Fit the washer (2) on the studs.
Install all other parts in the reverse
sequence.
– Line up the cylinder and gasket.
: Tighten down the cylinder base
screws in an alternate pattern,
b 3.5
2 1
: Screw home the decompression
valve (2), if fitted, and tighten it
down firmly, b 3.5
: Fit the cover (1).
Install all other parts in the reverse
sequence.
2
1
35