Stihl MS 460 Service Manual page 23

: Secure bell crank with E-clip
(arrow).
– Coat the brake band with chain
oil to protect it from corrosion and
help reduce "snatching" during
the first few brake applications.
: Attach brake band to the bell
crank (arrow).
– Position the brake band behind
the lugs on the crankcase.
22
: Push brake band into slot.
– Coat screw with Loctite and fit,
b 16.
– Tighten down the screw firmly,
b 3.5
a a
b
: The turns of brake spring must be
tightly against one another in the
relaxed condition. If this is not the
case, replace the brake spring.
: Check correct position of
protective tube:
a = 20 mm
b = 32 mm
: Attach brake spring to bell crank
(arrow).
2
: Use assembly tool (2)
1117 890 0900 to attach the
brake spring (1) to the anchor pin.
– Place cover in position.
: Insert screws (arrows) and
tighten down firmly, b 3.5
: Install clutch drum/chain
sprocket, b 5.1
MS 460, MS 460 C
1