Resetting Disks To Non-Raid - ECS P965T-A Manual

58

Resetting disks to non-RAID

An HDD that has been previously configured as part of another RAID set in
another platform is called a broken RAID HDD. When you install a broken RAID
HDD, you cannot select this HDD when configuring a RAID set through the
JMB361 utility.
If you still want to use this broken RAID HDD as part of the RAID set config-
ured through the JMB361, you may do so by resetting the disk to non-RAID.
You will, however, lose all data and previous RAID configurations.
To reset disks to non-RAID:
1 In the main JMB361 RAID BIOS menu, highlight Revert HDD to non-RAID using
the up/down arrow key then press <Enter>.
2. Use the space bar to select the HDD that you want to reset to non-RAID.
A selected HDD shows a sign
3. A dialogue box appears to confirm the action. Press <Y> to confirm; other-
wise, press <N>.
Pressing <Y> deletes all the data in the HDDs.
before it.
JMB361 RAID Setup Guide