ECS P965T-A Manual page 37

DelayPrior to Thermal (16 Min)
Enables you to set the delay time before the CPU enters auto thermal mode.
Thermal Management (Thermal Monitor 1)
This item displays CPU's temperature and enables you to set a safe temperature to Prescott
CPU.
TM2 Bus Ratio (0X)
This item represents the frequency (bus ratio) of the throttled performance state that will
be initiated when the on-die sensor goes from not hot to hot).
TM2 Bus VID (0.8375V)
This item represents the voltage of the throttled performance state that will be initiated
when the on-die sensor goes from not hot to hot.
Limit CPUID MaxVal (Disabled)
This item can support Prescott CPUs for old OS. Users please note that
must be set "Enabled", while under WinXP, it must be set "Disabled".
C1E Support (Enabled)
This item CIE (Enhanced Halt State) support allows users to decrease the bus ratio that
reduces the consumption of CPU electricity and power. This item shows only if the CPU
supports.
Execute Disable Bit (Enabled)
This item is a security feature that helps you protect your CPU and operating system
against malicious software executing code. This item is available when CPU supports the
feature.
Intel Vanderpool Technology (Enabled)
When enabled, a VMM can utilize the additional hardware capabilities provided by Vandor
pool Technology.
Removable Device Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
1. Floppy Disks:
2. LS120:
3. ZIP100:
4. USB-FDD0 :
5. USB-FDD1 :
6. USB-ZIP0 :
7. USB-ZIP1 :
: Move
F5:Previous Values
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
Menu Level
Use <
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
PU/PD/+/-:Change Priority F10:Save
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
under NT 4.0, it
Item Help
> or < > to
ESC:Exit
31