Table of Contents
Advertisement
368
8-2. Steps to take in an emergency
With the compressor switch off, disconnect the hose from the valve
14
on the tire and then pull out the power plug from the power outlet
socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
15
Attach the air release cap to the
16
end of the hose.
If the air release cap is not
attached, the sealant may leak
and the vehicle may get dirty.
Temporarily store the bottle in the luggage room while it is con-
17
nected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
18
safely for about 3 miles (5 km) below 50 mph (80 km/h).
After driving for about 3 miles (5
19
km), stop your vehicle in a safe
place on a hard, flat surface
and remove the air release cap
from the hose before recon-
necting the repair kit.
Advertisement
Table of Contents
