Wireless Lan Connection - ViewSonic PJD7383 User Manual

4. Press
projector or ENTER on the remote control.
5. Press
6. To save the settings, press MODE/ENTER on the projector or ENTER on the remote
control. If you do not want to save the settings, press MENU/EXIT on the projector
or Exit on the remote control.
7. Press
on the remote control.
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
• If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.

Wireless LAN connection

To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
1. Make sure the projector is turned on.
2. Press MENU/EXIT on the projector or Menu on the remote control and then press
/
3. Press
projector or ENTER on the remote control. The LAN Control Settings page is
displayed.
4. Highlight Wireless LAN Status and press MODE/ENTER on the projector or
ENTER on the remote control.
5. Check the information displayed on the menu.
You can change the wireless settings on the Network Control > Administrator Login >
Network Setup page. To access the page, see page
About AP and Infrastructure modes
In AP mode, you need to use your computer's wireless connection utility to search for the
projector's SSID and connect to it. Then you can search for the projector with vsPresenter.
In Infrastructure mode, you should connect both your computer and projector to the same
AP router and make connections with the IP address.
The following diagram describes how to access the Internet in AP and Infrastructure
modes.
40 Operation
to select the item you want to modify and press MODE/ENTER on the
/ to move the cursor and the press
to highlight Apply and press MODE/ENTER on the projector or ENTER
until the SYSTEM SETUP: Basic menu is highlighted.
to highlight LAN Control Settings and press MODE/ENTER on the
(AP mode)
Internet
/ to enter the value.
42 for details.
(Infrastructure mode)
Internet