Using The Projector In Standby Mode - ViewSonic PJD7383 User Manual

Using the projector in standby mode

Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
SYSTEM SETUP: Basic > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the Connection chapter.
LAN Control
Select On when you wish to control the projector over a network when it is in standby
mode.
Microphone
Select On when you wish to use a microphone in standby mode. Be sure you have adjusted
the SYSTEM SETUP: Advanced > Audio Settings > Microphone Volume menu to a
desired level before the projector is turned off.
Active VGA Out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received only
from COMPUTER IN 1.
Active Audio Out
Selecting On outputs an audio signal when the AUDIO IN 1 and AUDIO OUT sockets are
correctly connected to devices. The projector outputs the audio signal received only from
AUDIO IN 1.
Operation 57