6.2.2 To open the outdoor unit
6.3 Mounting the outdoor unit
6.3.1 About mounting the outdoor unit
6.3.2 Precautions when mounting the outdoor unit
3(A)MXM+3(A)MXF+4MXM+5MXM
R32 Split series
4P600463-1B – 2020.05
DANGER: RISK OF ELECTROCUTION
Do NOT leave the unit unattended when the service cover is removed.
DANGER: RISK OF ELECTROCUTION
DANGER: RISK OF BURNING
When
The outdoor and indoor unit must be mounted before the refrigerant piping can be
connected.
Typical workflow
Mounting the outdoor unit typically consists of the following stages:
1
Providing the installation structure.
2
Installing the outdoor unit.
3
Providing drainage.
4
Protecting the unit against snow and wind by installing a snow cover and baffle
plates. See "Preparing installation site" in "5 Preparation" [
INFORMATION
Also read the precautions and requirements in the following chapters:
▪
General safety precautions
▪
Preparation
3×
2
6
Installation
|
4
21].
Installer reference guide
29