Setting The Stuffing - Triax CCS 483 Assembly Instruction Manual

Setting the stuffing

Bx 1A STUFFING:
SR=6900 (6531)
SR=6900 (= "Number 1"): Active output symbol rate
(6531) (= "Number 2"):
• Use the
number to be changed ("Number 1") and set the symbol
rate with the buttons
The value set corresponds to the new output symbol rate.
Note:
– Increase the value of "Number 1"
—> The "Number 1" can be increased to any value up to
– Reduce the value of "Number 1".
—> With the station filter switched "on", the "Number 1"
/
◀ ▶
/
–
+
Bx 1A
SR=6900 (6531)
Number 1
The current measured output symbol rate.
If the station filter is activated, this value is lower than
the value of the "Number 1". The value fluctuates,
since the data rates of individual stations are dynami-
cally modified by the broadcasters.
/
buttons to place the cursor under the
◀ ▶
7,000.
can be decreased. To do this, observe the "Number
2" for 30 seconds and note the highest value. Add
roughly 10 % to this value. Do not decrease the
"Number 1" lower than the value of "Number 2".
Is the "Number 1" lower than "Number 2" question
marks "??" appear in the display.
Bx 1A
SR=6250 (6531) ??
- 28 - - 28 -
STUFFING:
Number 2
.
STUFFING: