Vermont Castings Encore 2550 Installating And Operation Manual page 17

Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations
The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in-
stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances
must adhere to the guidelines stated in the clearance chart on Page 14.
Dimensions indicated are valid for installations with either 6" or 8" flue collars.
Encore: WITHOUT Stove and Chimney Connector Heat Shields
Unprotected Surfaces
Parallel Installations
Side (A)
37¹⁄₂"
(953 mm)
A
*
* This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page:
35" in the United States and 37" (940mm) in Canada.
Encore: WITH Stove and Chimney Connector Heat Shields
Unprotected Surfaces
Parallel Installations
Side (A)
37¹⁄₂"
(953 mm)
A
**To locate center of flue collar for corner installation, add 7" (180mm) to the clearance distance from stove corner to wall. Mark
off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out from the
walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the diagrams above.
2000956
Corner
Installations**
Rear (B) Corner (C)
27³⁄₄" 31"
(705 mm) (787 mm)
B
C
Corner
Installations**
Rear (B) Corner (C)
15³⁄₄" 24"
(400 mm) (610 mm)
B
C
ST632a
Encore
flue centerline
Diagrams
02/01
Parallel Installations
Side (A)
21¹⁄₂"
(546 mm)
D
*
ST632
Encore
flue centerline
Diagrams
2/01
Parallel Installations
Side (A)
21¹⁄₂"
(546 mm)
D
Encore Woodburning Stove
Protected Surfaces
Rear (B)
11³⁄₄"
(299 mm)
E
Protected Surfaces
Rear (B)
7³⁄₄"
(197 mm)
E
Corner
Installations**
Corner (C)
15"
(381 mm)
F
ST632
Corner
Installations**
Corner (C)
14"
(356 mm)
F
ST632a
17