Table of Contents
Advertisement
Glass Information
Only glass approved by Vermont
Castings, Majestic Products should be
used on this fireplace.
•
The use of any nonapproved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
•
Replacement glass (complete with gasket) is
available through your Vermont Castings,
Majestic Products dealer and should be
installed only by a licensed qualified service
person.
Louvre Removal
Remove the louvre assembly top by lifting the panel up
and out from the fireplace. (Fig. 41)
The louvre assembly bottom is hinged at the bottom
edge and swings down.
2.
1.
Fig. 41 Remove louvre assembly top.
Window Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating, allow time for the
components to cool.
3. Remove the louvre assembly top.
4. Open the louvre assembly bottom.
5. Release the two (2) clamps along lower edge of the
frame by pulling down on clamp handles. (Fig. 42)
6. Tilt window frame assembly out slightly at the
bottom, lift the frame up and away from the
fireplace.
7. To replace window frame assembly, reverse this
procedure.
10002428
Vermont Castings, Majestic Products DVRT36/ 39/ 43
Operating Instructions
Louvre
Assembly Top
Window Frame Assembly
FP444
Window
Frame
Assembly
Fig. 42 Window frame assembly removal.
Glass Cleaning
It is necessary to periodically clean the glass panel. It
is normal for condensation to form on the inside of the
glass during start-up. This condensation causes lint,
dust, and other airborne particles to cling to glass
surface. Also, initial paint curing may deposit a slight
film on the glass.
Cleaning the glass two or three times within the first
few weeks of operation is recommended, using non-
ammonia based household cleaner and warm water, or
gas fireplace glass cleaner.
After the initial cleaning process, the glass should be
cleaned two or three times during each operating
season, depending on the environment in the house.
Clean the glass after the first two weeks
of operation.
Do not clean glass when it is hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Lower
Clamps
Window
Frame
Assembly
Pull Clamp
Push
Hook
Clamp
Handle
FP1191
25
Hide quick links:
Advertisement
Table of Contents
