Basic Function Setting; Changing Input Type; Sv Setting; Setting Pid Values Automatically - Taie FY400 Operation Manual

9. Basic Function Setting

9.1 Changing Input Type

1.
3.
5.

9.2 SV Setting

1.
3.
9.3 Setting PID Values Automatically(Autotuning)
1.
3.
5.
9.4 Setting PID Values Manually
PV
1.
SV
PV
3.
SV
PV
5.
SV
FY operation manual
Display after power-on.
Press key the lower
display flashes.
Press key to store new
value of INP1.
Display after power-on.
Press key and
key to adjust set value.
Display after power-on.
When key is pressed,
the lower display flashes.
Press key to store new
value of AT.
Display after power-on.
When key is pressed,
the lower display flashes.
Press key to store new
value of P1.
2.
4.
Modify input type needs to interchange of jumper location,
and it needs to recalibration for linear input type change.
Please refer to chapter 15. "Input type modification".
2.
4.
2.
4.
When auto-tuning AT LED lamp lit and start to output,
through a few circles to get new PID value with the precise
control, if finished the AT LED will be lamp off.
2.
PV
4.
SV
By the same procedure, use the same ways to set integral
time(I1) and derivative time(D1).
Hold key + key 3
seconds, to enter LEVEL_3
upper display showing
"INP1" with lower display
showing current input type.
Press key and
key to enter the intended
input type.
When key is pressed,
the lower display flashes.
Press key to store
new value of SV.
Press key until show
"AT" 。
Press key or
key to select auto-tuning
execution or not.
Hold key 3 seconds,
then entering into LEVEL_2
upper display showing "P1",
with lower display show
current P1 value.
Press key and
key to set the intended P1
value.
24