Separation Of Recorder Holder - Canon MV750i E Service Manual

1-9 Separation of Recorder Holder

(1) Remove three screws (d × 3), and detach the Spring, Recorder Holder, Insulation Rubber and Sheet.
<Note on Reassembling>
(1) When using the Insulation Rubber supplied as a service part, apply Hanarl KS-39M (DY9-3053-000) to the entire surface of the
Insulation Rubber.
(2) Position the Sheet as illustrated.
(3) Position the Spring as illustrated.
(4) Attach the UL Tape to the position indicated in the figure.
<Instruction for Supply>
Entire surface of Insulation Rubber : Hanarl KS-39M (DY9-3053-000)
(1)
DMC III
d
Recorder Holder
3.4mm
Metal
M1.4
Stepped Screw
Note on Reassembling (2)
Conceal the holes
for screws while
paying attention
not to go beyond
the Recorder Holder.
Sheet
Insulation Rubber
(1) - d
Note on Reassembling (4)
Outline reference of flexible
cable: +1 mm,−0 mm
Be sure to cover the patterned
part.
The outline step-difference part
Sheet
of the DMC chassis shall be
used as the reference level.
Guideline for attaching±1mm
Fig. 8
11
MV750i E, MV730i E, MV700i E, MV700 E, MV690 E
Note on Reassembling (1)
Instruction for Supply
Insulation Rubber
Spring
Insulation Rubber
Note on Reassembling (3)
DISASSEMBLING
Insulation Rubber
Hanarl KS-39M
(1) - d
Spring
UL Tape
(9 × 20)
DMC III