Device Pairing - Crestron TSW-560 Product Manual

Once a new application is selected, click Save Changes from the Actions menu. A pop-up dialog box
is displayed stating that the touch screen must be rebooted for the new application to take effect.
Click Yes to reboot the touch screen now or Noto reboot the touch screen later. The touch screen
reboots with the new application running.
NOTE: Each application uses a unique setup procedure for registering and configuring the
application. For more information on setting up each application, refer to
page 58).

Device Pairing

Click Device Pairing to configure settings for pairing the touch screen to a CEN-ODT-C-POE. The
CEN-ODT-C-POE provides local occupancy reporting for supported room scheduling apps.
NOTE: For more information on the occupancy sensor, refer to the CEN-ODT-C-POE Quick
Start (Doc. 8258) at www.crestron.com/manuals.
Settings Tab - Device Pairing
Device Model: Use the drop-down menu to select POE Occ Sensor.
l
Pairing Retry Time (Mins): Enter a duration (in minutes) that must elapse before the
l
CEN-ODT-C-POE reattempts to pair to the touch screen.
Pairing Status: Reports whether the CEN-ODT-C-POE is paired to the touch screen (Online)
l
or not (Offline).
Device IP Address/FQDN: Enter the IP address or fully qualified domain name of the
l
CEN-ODT-C-POE. This is required for device pairing.
Device Authentication: Enter authentication credentials for the CEN-ODT-C-POE (if
l
required):
Device Username: Enter a valid username used to access the device.
o
Device Password: Enter a valid password used to access the device.
o
56 • TSW-560, TSW-760, and TSW-1060
Application Setup (on
Product Manual — Doc. 7927K