Table of Contents
Advertisement
- One Gas Ducted Heater
- One Gas Ducted Heater + one Evaporative Cooler
- One Gas Ducted Heater + one Add-On
Note: For Refrigerated Cooling connection, heater parameters
(H01) must be programmed.
3.9 System with Zones (Inc. ZonePlus)
For systems installed with zones, the Touch Controller
parameters need to be changed. The appliance cannot be started
until all system zoning parameters have been programmed. Once
the zoning parameters have been programmed the system may be
run in either Manual or Schedule mode. For specific appliance
installation parameters refer to the relevant appliance installation
manual and appendix contained within for zoning parameters.
Refer to ZonePlus manuals for detailed information on STSP
or MTSP systems or contact Technical Support.
3.10 System Operation
Instruct the home owner on system operation including:
System design – MTSP or STSP
•
Zone identification
•
Minimum / maximum no. of simultaneous zones for design
•
conditions for Heating and Cooling (if fitted)
Common Zone operation (if applicable)
•
Constant Zone operation (if applicable)
•
Operating the system in manual mode
•
Auto Operation – programming the Comfort Schedule
•
3.11 Service Notification Message
When the operating hours logged for an appliance exceeds the
predetermined period, the Touch Controller displays the following:
Diagram 21: System Alert
The Spanner icon appears flashing
at one second intervals.
The "
" icon is displayed with the Alert text flashing
at one second intervals.
Pressing the "
" icon will result in the following message being
displayed for either Heater or Evap Cooler fan run hours above
limit, refer Diagram 22.
15
Hide quick links:
Advertisement
Table of Contents
