Clean The Outlet Hose At The Siphon; Filter In Water Supply Blocked - Bosch WAN280H1 Installation And Operating Instructions Manual

Table of Contents

Advertisement

Cleaning and maintenance
en
Pour 1 litre of water into
17.
compartment II and start the
Schleudern/Abpumpen (Spin/Drain)
programme. This will prevent
detergent from flowing straight into
the drain during the next wash.
You have now successfully cleaned the
drain pump.
Clean the outlet hose at the
siphon
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and carefully
3.
remove the outlet hose.
Residual water may leak out.
Note:
Clean the outlet hose and siphon
4.
connecting piece.
46
Re-attach the outlet hose and secure
5.
the connection point using the hose
clamp.

Filter in water supply blocked

Turn off the tap.
1.
Set any programme (except Rinse/
2.
Spin/Drain).
Press Start/Nachlegen (Start/
3.
Pause).
Allow the programme to run for approx.
40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Clean the filter on the tap as follows:
Disconnect the hose from the water
1.
tap.

Advertisement

Table of Contents
loading

Table of Contents