Sensors; Continuous Automatic Load Adjustment Function; Unbalanced Load Detection System - Bosch WAN280H1 Installation And Operating Instructions Manual

Sensors

en
Release Start/Nachlegen (Start/
3.
Pause).
Setting mode is now activated.
The following programme positions are
assigned to the basic settings:
Position Basic setting
Adjust the volume of the audible
0
notification signals (e.g. at the end
of a programme).
Adjust the volume of the audible
8
operating signals.
--------
Settings:
0 off
1 low
2 medium
3 max
4 very high
Adjust and activate/deactivate the
basic settings as follows
Position of the required basic
1.
setting.
Change the setting using:
2.
Fertig in (Ready in)
Adjust any additional basic settings
3.
you require or save and exit the
basic settings.
Save and exit the basic settings as
follows
Switch off the appliance.
The selected settings will be
Note:
retained even after the appliance has
been switched off.
36
H
Sensors
C ontinuous automatic load
S e n s o r s
adjustment function
Depending on the type of fabric and
load, the continuous automatic load
adjustment function optimally adjusts
the water consumption and programme
duration in each programme.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping the drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.