Table of Contents
Advertisement
Unpleasant odour in the appli-
ance
The duration of the pro-
gramme changes during the
wash cycle
The programme is taking
longer than usual
Water remaining in the care
product compartment i
Water is not visible in the drum Not a fault – the water is below the visible area.
The drum briefly jerks or jud-
ders after the programme has
started
Loud noises, vibrations or
machine "wandering" during
the spin cycle
Water is leaking from the
machine.
If you cannot rectify a fault yourself (after switching the appliance off and then on again) or a repair is re-
quired:
Switch off the appliance and pull the mains plug out of the socket.
■
Turn off the tap and call the after-sales service.
■
--------
Run the Baumwolle (Cottons) 90 °C programme without any laundry.
Add all-purpose washing powder or a detergent that contains a bleach-
ing agent.
To prevent foaming, only use half the amount of detergent recom-
Note:
mended by the detergent manufacturer. Do not use detergents intended
for woollens or delicates.
Not a fault – the programme sequence is optimised for the specific wash-
ing process. This may change the programme duration.
Not a fault
The unbalanced load detection system is eliminating an imbalance
■
by repeatedly redistributing the laundry
Foam detection system switches on a rinse cycle if foam formation is
■
too high
Clean the insert ~ Page 38
The effectiveness of the care product is not affected.
Note:
The internal motor test may cause the drum to jerk or judder briefly when
the wash programme starts.
Make sure that:
The appliance is correctly aligned ~ Page 17
■
The appliance feet are fixed~ Page 17
■
The transit bolts have been removed ~ Page 13
■
Make sure that the drain hose is properly secured and is not dam-
■
aged.
Check the threaded joint on the supply hose, and tighten it if neces-
■
sary.
Cleaning and maintenance
en
43
Advertisement
Table of Contents
