ELNA 6200 Service Manual page 29

REPLACING DC MOTOR AND ADJUSTING MOTOR BELT REPLACING DC MOTOR AND ADJUSTING MOTOR BELT REPLACING DC MOTOR AND ADJUSTING MOTOR BELT
REPLACING DC MOTOR AND ADJUSTING MOTOR BELT REPLACING DC MOTOR AND ADJUSTING MOTOR BELT
T O R E M O V E : T O R E M O V E :
T O R E M O V E : T O R E M O V E : T O R E M O V E :
1. REMOVE THE BELT COVER (SEE PAGE 8).
2. DISCONNECT THE MOTOR CONNECTOR.
REMOVE THE TWO SETSCREWS, THEN REMOVE THE DC MOTOR AND BELT.
T O A T T A C H : T O A T T A C H : T O A T T A C H : T O A T T A C H : T O A T T A C H :
SET THE MOTOR IN MACHINE AND REPLACE SCREWS.
REPLACE THE MOTOR BELT.
WHEN APPLYING APPROXIMATELY 300 GRAMS PRESSURE IN THE MIDDLE OF THE BELT, IT SHOULD DEFLECT
7 TO 9 MM WHEN SET PROPERLY.
TIGHTEN THE SETSCREWS.
ATTACH THE BELT COVER.
TENSION TENSION TENSION TENSION TENSION
MOTOR CONNECTOR
PRESSURE 300G
BELT DEFLECTION
7~9 MM
DC MOTOR (UNIT)
SETSCREWS
(2)
28
BELT