Adjusting Presser Foot Height And Alignment - ELNA 6200 Service Manual

ADJUSTING PRESSER FOOT HEIGHT AND ALIGNMENT

WHEN THE PRESSER FOOT IS RAISED, THE CLEARANCE BETWEEN THE PRESSER
FOOT AND THE NEEDLE PLATE SHOULD BE 5.7 TO 6.3 MM.
1. REMOVE THE FACE COVER AND RAISE THE PRESSER FOOT.
LOOSEN THE SETSCREW TO ADJUST PRESSER FOOT HEIGHT (6.0 MM) AND PRESSER FOOT
ALIGNMENT.
2. TIGHTEN THE SETSCREW FIRMLY.
3. ATTACH THE FACE COVER.
SETSCREW 4 X 8
[HEIGHT OF PRESSER FOOT]
PRESSER FOOT
NEEDLE PLATE
5.7 TO 6.3 MM
、
FEED DOG
10
P R E S S E R F O O T
LIFTER
PRESSER FOOT ALIGNMENT
SHOULD BE
PARALLEL